Ultimate Personalized Name Bookmark

About this generator

Ultimate Personalized Name Bookmark is a free MakerWorld customizer that turns a name or short word into a clip-on bookmark. The name sits in raised letters on a tab that follows the outline of the word, and a long slotted stem below slides over a page like a paper clip, so the name sticks out above the book. Designer B W R M published it in May 2026, and it has close to 19,000 customizations.

Click Customize on the model page and type the name. You choose one of 10 fonts, including Arial, Montserrat and Roboto, and set the total length and width, the base thickness and the letter height with sliders. It runs in MakerWorld's Parametric Model Maker. The designer has protected the OpenSCAD file, so that form is the only way to change it.

For the two-color look, start with a dark filament and add a filament change at the layer where the letters begin. There is also one print profile, set up for an AMS with black and white PLA, which puts the sample name at about 10 g and 27 minutes. The designer recommends 100% infill so the thin stem does not snap, although that profile is saved at 15%. It suits readers, teachers and anyone after a quick gift for a book lover.

What you can make

• Name bookmarks that clip onto a page
• Single-word bookmarks
• Two-color bookmarks with a filament swap
• Small gifts for readers and classmates

How to use Ultimate Personalized Name Bookmark

1. Open the model on MakerWorld, log in and click Customize
2. Type the name and pick one of the 10 fonts
3. Set the length, width, base thickness and letter height with the sliders
4. Generate and download the 3MF or STL
5. Print at 100% infill with a filament change where the letters begin